GLUES...Zap-a-Gap.
Gap filling formula Allows 7 to 10 sec for positioning,
20 sec cure time.
GLUES...Zap/CA
Super-thin. Penetrating formula. Bonds in 1 to 5 seconds.
GLUES Devcon
...5 minute epoxy, the best 2 part glue on the market
by far. Sets crystal clear.
GLUES
...151 epoxy. 10 minute cure two part rapid epoxy
in convenient dual delivery 50/50 tube.
MILLIPUT...The
epoxy with a thousand uses. A 2 part self hardening,
non shrinking epoxy putty. Highly adhesive to
most materials. Excellent for setting glass eyes.
ABRANET...
70 x 125mm sheets, sold in packs of 10.
HERMES...Velours
backed roll, 115 mm white coloured medium weight Aluminium
Oxide Resin Bonded paper. Sold by the meter.
SELF
PAINTING GLASS EYES... Sold in pairs on wire. Clear
with black pupil.
SOLID
BLACK GLASS EYES... Sold in pairs on wire.
ACRILIC
PAINTS...18 colour 12ml tubes.
CLEAR
EMBEDDING RESIN... Ideal for small clear water-white
castings, between 10-50g in weight.
This polyester resin is pre-activated and will
cure by the addition of 2% of Liquid Catalyst for
castings up to 25g The setting time for this
product is about 25 minutes.
Cannot be shipped overseas due to 'hazardous
substances' regulations.
2
INCH COTTON MOP...2 x1" cotton loose mop. Ideal
for getting in the inside radius of horn crooks. Do
not contaminate mops with different polishing compounds.
3
INCH COTTON MOP... Loose 3"x1 (75mm x25mm) Ideal
for getting in the inside radius of horn crooks.
Do not contaminate mops with different polishing compounds.
4
INCH COTTON MOP... Loose 4"x1" (100mmx25mm)
PIG
TAIL ADAPTER...Standard Mop Taper Heavy Duty. For
use in a standard hand held drill chuck.
1
INCH COTTON MOP + MANDRIL...A 1 inch stitched cotton
mop and mandrill perfect for polishing inside
the nose of horn crooks. Sold in a pack of two. Do
not contaminate mops with different polishing compounds.
For use in flexible shafts.
POLISHING
COMPOUND... Lustre. Ideal for preparatory polishing.
Do not contaminate mops with different polishing
compounds.
POLISHING
COMPOUND... Hyfin. For final finishing, removes fine
abrasive marks. Do not contaminate mops with
different polishing compounds.
CABINET
SCRAPER... made from high carbon steel, hardened and
tempered to 470 vickers and polished to give
a smooth finish. It has a good edge retention but
is easily re-sharpened. Much over looked, ideal for
refining and removing file marks working with
the grain of wood and horn.
SPOKE
SHAVE...A smaller, lighter spokeshave with a flat
base for work on convex surfaces. manual adjustment
of the 1.3/4in wide cutter. A nice little tool for
shanking wooden tops and shaping crooks. Not suitable
for horn.